ISOLATOR-BALANCERS

Low cost. Small Size. For eliminating ground loops with connected equipment. Converts tube amp unbalanced input to balanced. Recommended in size or cost critical situations where reduced bandwidth is acceptable. +12.5 dBu. SIZE B DIMENSIONS

General purpose. For eliminating ground loops with connected equipment. Our Best Seller for trouble shooting installations. Converts tube amp unbalanced input to balanced which can then be driven from balanced or unbalanced sources. max level +26 dBu. May be used as a phase splitter for a balanced amplifier. 100% Mumetal core. Tested with Drip Electronics Altec 436C PCB. Mumetal can.Style f OCC wire option

High level. For eliminating ground loops with connected equipment. Converts tube amp unbalanced input to balanced. Hybrid core 50% Mumetal 50% Radiometal. Recommended where maximum headroom is required. +29 dBu. .

Low cost. Small size. For isolating and balancing a low impedance input or output +3 dBu. SIZE B DIMENSIONS

General purpose. For isolating and balancing a low impedance input or output. High performance Sowter generic transformer similar to Triad HS-56 (in overall 1:1 configuration) Suitable for Pulteq EQP-1A line input. Suitable for balancing and/or isolating the output of a CD player or sound card. Total dc resistance 160 ohms Max level +17dBu (5V). OCC wire option
Tested with Drip EPQ1A (Choose threaded grommet type 3603E)

150 +150 / 600CT input transformer. Configurable for 150/600CT Ohms or 600/600CT Ohms. 100% Mumetal core and can. Internal electrostatic shields for maximum nnoise rejection. Available with octal base if required. A very high spec transformer with excellent bandwidth, minimal distortion, high level capability with minimal insertion loss. Primary inductance (typical) 12.7 H DCR 13 Ohms max. Secondary DCR 23 Ohms max. Max input level +21 dbu at 50 Hz. Can be used as replacement for obsolete type 3497 by connecting the primmary windings inseries.

4 identical 150 ohm windings quadrifilar wound. A multipurpose transformer with an incredible HF response. +34 dBu

High level line output. Ideal for isolating outputs or can be driven from a single or pair of op amps. Faraday shields for high CMR +34 dBu output level. Can be configured as 75/600 Ohms (primaries in parallel) or 300/600 Ohms (primaries in series). Replacement for Neve LO1173.

High level, high impedance to line output. Can be wired as 4:1CT or 8:1 +32 dBu at 50 Hz secondary level in 600 ohm configuration. Faraday shields for high CMR.